CBR250 Forums banner

Bar end issue

1758 Views 5 Replies 5 Participants Last post by  aj26
I was trying to unscrew one of my bar ends it seems that the whole inner tube of the bars is turning.... Any ideas? Am I even close with what may be happening?

Any suggestions on getting the bar end undone?

Cheers,
1 - 6 of 6 Posts
See if you can just pull it out but otherwise hold the bar end weight then unscrew. I had a similar problem.
dazz245 said:
See if you can just pull it out but otherwise hold the bar end weight then unscrew. I had a similar problem.
Been trying to pull it out but wasn't actually sure if anything would come out.... If I were to yank on the bar end would an inner tube come out?

I did try and hold the bar end but it seems that the screw has cemented itself to the bar end and they both move together....
nothing is gonna come out that you dont want to come out...just pull on it!
Is it happening on both sides? It sounds like you are doing something wrong if it is.


Work out what's making them stick on the left hand bar so as to not do damage to the throttle on the right.
I drilled mines out so I can install the oxford universal ones, is there anyway to buy the insert?
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top