CBR250 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello all!

The bike is a mc17 with a mc19 engine and carburetor, it has a mc17 cdi and an oem reg/rec. The bike starts fine, runs fast but after 3 minutes or so of riding or idling it stalls and is difficuilt to start but will eventually fires up. The carbs are clean, coil packs are 3.2ohms tested with a DMM however the pulse trigger registered a 465-470 ohms on both. I am about to buy a cdi, a coil pack and a pulse trigger but i am reluctant because it will be a bit pricey and im afraid of having to spend that much but the bike would still be acting the same... Need some advice from the masters..
 
1 - 2 of 2 Posts
Top