CBR250 Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter #1
Hello I have parts sale


MC22 Clipons. I have 2 sets. Looking for around $70 for the better set and $50 for the rusty one. Neither of them have the bar ends or the holders. (Pic below and disregard the bar end - it's not included) Condition is average to good for the better pair and poor for the rusty one.

MC22 Calipers. Condition = Poor
The pistons in the calipers are pitted and scratched but they still seem to work fine. About $50 and comes with old hoses.

Here are some pics:




Various Carb bits - everything except needles free to good home. Needle's $25 for all. Very good condition.
Pics:








Medium Ruger scope rings for a M77 Hawkeye Stainless. Will fit on many other Ruger arms. Cost round $150 new, asking for about $80.


CBR600RR rear sprocket bolts. Looking for $30 for all of them. I think it's off an 07 model.

Dainese Gran Premio Pelle size 44. Too small and need to sell it, pretty clean. It's in Blu-river/Rosso-6/Bianco. Looking for round $300. Pics below but can get more.


http://www.dainese.com/wd_en/motorbike/g-gran-premio-pelle.html
 

·
Registered
Joined
·
265 Posts
RE: MC22 Front End plus carb bits and scope rings

Dammit, where were you 5 months ago !!! My stacked project bike could have done with all of that !
 
R

·
Guest
Joined
·
0 Posts
RE: MC22 Front End plus carb bits and scope rings

Front end.... what you asking? PM'd
 

·
Registered
Joined
·
861 Posts
Discussion Starter #7
RE: MC22 Parts and DAINESE Jacket 07 CBR600RR sprocket bolts UPDATE

Bump updated, Dainese Jacket for sale
 

·
Registered
Joined
·
1,401 Posts
RE: MC22 Parts and DAINESE Jacket 07 CBR600RR sprocket bolts UPDATED

Is the Dainese jacket Euro size or US size?

Also, where are you?
 

·
Registered
Joined
·
87 Posts
RE: MC22 Parts and DAINESE Jacket 07 CBR600RR sprocket bolts UPDATED

Interested in the jacket. Give me your number and I'll give you a call.
 

·
Registered
Joined
·
861 Posts
Discussion Starter #12
RE: MC22 Parts and DAINESE Jacket 07 CBR600RR sprocket bolts UPDATED

shvlzz said:
Is the Dainese jacket Euro size or US size?

Also, where are you?
I'm not to sure on that, no where within the jacket that I can see does it say what size system it uses but being an Italian brand I would assume Euro.

Best to try one out in store just to see what is right. I'll have a look in the manual/pamphets to see what they say about sizing.[hr]
Just did some research and Dainese uses Euro size

http://www.sydneycitymotorcycles.com.au/shop/DaineseSizeCharts.htm

Here's a size chart going from Dainese to US sizes.

Also I'm located in country victoria, Rushworth 3612 so I assume picking up may be hard although postage will be free on the jacket.
 

·
Registered
Joined
·
861 Posts
Discussion Starter #15
RE: MC22 Parts, DAINESE sz44, and Aprilia RS250 Front end

bump - improved title and original post.
 
1 - 15 of 15 Posts
Top