[Ninexz]

Would anyone be able to give me an insight as to how its done?
Forks are off, and I have removed the middle nut of the triple clamp.
I thought it would just lift off when that nut was loosened, obviously not.

Im taking the frame to the powdercoaters so I gotta get everything out.

Thanks in advance.

 

[richo]

Unless it's somehow different to my R6, the top triple just slides straight off....

 

[Ninexz]

I've been sitting on the frame and tugging as hard as I can, still no result.

 

[dayeve]

Give them a tap with a rubber mallet. Tap the bearings out with a punch or a cold chisle.

Edit, spelling.

 

[sir.b]

I've been sitting on the frame and tugging as hard as I can, still no result.

Must.... not.... comment.....

Justin.

 

[Ninexz]

I've been sitting on the frame and tugging as hard as I can, still no result.

Must.... not.... comment.....

Justin.

yeah, after I cleaned up after myself, I went and had another go at getting my triple clamp off.

 

[Lane]

I've been sitting on the frame and tugging as hard as I can, still no result.

Must.... not.... comment.....

Justin.

Hopefully someone sig quotes him!

 

[dazz245]

The lower head bearing is really hard, it took me 2 hours with a screw driver but I was being careful not to scratch the stem.

 

[sir.b]

I've been sitting on the frame and tugging as hard as I can, still no result.....

The lower head (bearing) is really hard, it took me 2 hours with a screw driver but I was being careful not to scratch the stem.......

I'm not even needed around here anymore

Justin.

 

[turlock]

seriously you need to get a rubber mallet to it. Had the same issue as you and that sorted it

 

[Ninexz]

I've managed to get it off,
ended up twisting the triple all the way to one side while lifting up.
Took about 5 minutes. the thing was on there good.

 

[juxt]

I've managed to get it off

tugging will do that!

 

[DamoC]

I've managed to get it off

tugging will do that!

Talking from daily experience eh.