CBR250 Forums banner
1 - 3 of 3 Posts

· Registered
107 Posts
Discussion Starter · #1 ·
Hey guys, so ive been cleaning my carbs/servicing my MC19. when i pulled out the plug cap to change the second cylinder from the left when sitting on the bike, the whole plug cap and lead came out. That cylinder never seemed to be firing right because it was always cooler then the rest. The end of the lead was a bunch of mangled wires and it had blue residue all over and when i tried to screw it back in it was not tight at all.

So my questions are:
1. Can i replace this lead, and only this lead with a new HT lead, or should i replace all the leads.

2. Also, is it easy to replace the lead from the plug cap? or is it a hard to do and better to order leads from honda?

i really need a new lead so i can get my bike back on the road!

Thanks guys
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.