CBR250 Forums banner
Cancel

RVF400 no go

4763 Views 16 Replies 10 Participants Last post by  Aduro, 
C
OK so I'm fitting a Tyga kit right? All is well until I went to start the blessed thing, and it appears I've perhaps bumped something loose.

The symptoms.

Battery reading 12.8 v so its healthy. It was working fine the day before.
I get none of the dash lights when I turn the key, but
all the fuses are fine.

So I took the kit back off, and can't find a loose connection anywhere!

Anything stupidly simple spring to mind I might've missed?

I'm also having difficulty locating Studs cbr250.com no start thread from the old forum. Can someone post the link?
Reply
Save
Like
1 - 1 of 17 Posts
J
there is usually a 30 amp fuse at the solenoid a bit tricky to find and if t goes pop then no lights

been a while since i looked , i would start at the battery and work down the cable from there , its under a rubber cap usually
Reply
Save
Like
1 - 1 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
CBR250 Forums
A forum community dedicated to Honda CBR250 & CBR250R motorcycle owners and enthusiasts. Come join the discussion about reviews, racing, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
CBR250 Forum Buy & Sell Maintenance New Member Introductions
Top