CBR250 Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
Hi all, just started my 1990 mc22 after doing valve clearance, hasn’t been started in over 2 years, been doing lots of work to it slowly. Went over the clearance so many times because it was my first and didn’t want to mess it up, started heaps easy but they are way louder now.
All were very tight past tolerance, needed 14 new shims, went looser where they fell between shim sizes (.2 increment shims), but aimed for exact spec 0.16 intake / .23 exhaust
Does this sounds too tight or too loose in the videos, picture is what a guy on fb said in my post. Going to recheck them all and go from there.

Thank you Valve noise


1 - 1 of 1 Posts