Leads from left to right sitting on bike.
Coil 1. Coil 2
/ \. / \
2. 3. 1. 4

The above numbers are cyclinders
Cyclinders are numbered 1-2-3-4 from left (side stand side) to right rear brake side.

The wiring from memory is black on right spade terminal and coloured on left.

Wiring is only long enough to fit correctly.

Close inspection you should see numbers on either end on coil ( black high tension leads) leads.

 

^^ what he said. Plus, the numbering on HT leads may not be correct if they were ever replaced or swapped around so don't take that as gospel.

As for wiring, the major yellow & minor blue wire plugs into the RH coil while the major blue & minor yellow wire plugs into the LH coil. As DMC said though, the loom is only long enough to fit where it needs so it should be pretty obvious if you get it wrong.